• Residential and commercial use
• Traditional applications and overlay applications
• Concrete pavers, natural stone, wet cast products and clay pavers
• Streetscape, commercial work, steep slope, pool areas, patios, walkways, driveways and parking areas

FEATURES & BENEFITS: 

• No Dust, Haze Free, No Blower, and One Watering
• For Traditional applications, rain safe 15 minutes after water activation
• For Overlay applications, rain safe 24 hours after water activation
• Used for joints up to a maximum of 4″ (10 cm) in traditional application
• Used for joints up to a maximum of 2″ (5 cm) in overlay application
• ASTM C144 gradation allows use in even the tightest joints
• OSHA silica crystalline compliant (OSHA 29 CFR 1926.1153)
• Works above 32°F (0°C)
• Ideal for Gator Base applications
• Can be used on false joint pavers
• Waterproof bags: Lay bag flat on its back, so front of the bag is facing you. Intact pallets can be stored outdoors

IMPORTANT INSTALLATION NOTES:

1. Always refer to the latest GATOR MAXX G2 Technical Data Sheet (TDS) at AllianceGator.com before installing GATOR MAXX G2.
2. Pavers and slabs must be installed according to ICPI Tech Spec #2 traditional base (www.icpi.org) before GATOR MAXX G2 installation. For overlay, ICPI recommends 2″ (5 cm) diameter drainage holes spaced approximately 10 ft (3 m) apart and at the lowest elevations in the slab. Holes should be filled with 3/8″ (9mm) stone and covered with a 1 ft x 1 ft (30 cm x 30 cm) patch of Gator Fabric GF4.4. Drilled holes should allow any water entering the bedding layer to freely flow out.
3. Pavers’ sides and top surfaces must be completely dry. Do not apply if the paver surface is damp or wet. The damp or wet surface will cause GATOR MAXX G2 to prematurely activate and will lead to the polymers sticking on the paver surface.
4. Do not apply if the paver joints are damp or wet. This will prevent the GATOR MAXX G2 from properly sliding into the joints and obtaining very densely packed joints, which is critical to the product’s performance.
5. Temperature must be above 32°F (0°C) with dry conditions and a minimum of 15 minutes of dry weather required after activation in traditional application and 24 hours in overlay applications.
6. For all paver surfaces, and particularly around in-ground pools, there must be a minimum slope of 1/8″ (3 mm) per linear foot (30 cm) away from the edge of the pool or structures to ensure optimal performance of the GATOR MAXX G2.
7. For the pool coping units, it is mandatory to use mortar in the joints. For the rest of the paver installation around the pool, you can use GATOR MAXX G2.
8. Do not sweep GATOR MAXX G2 over asphalt.
9. GATOR MAXX G2 level, must be at least 1/8″ (3 mm) below top of paver’s surface or 1/8″ (3 mm) below the chamfer or erosion may occur. The filled and cured polymeric sand joints should never be in direct contact with foot traffic or tire.
10. For textured or pre-finished surfaces, we recommend to remove all the sand from the paver or slab surface prior to using the plate or roller compactor.