Description
SUPERSAND BOND is a unique mixture of polymer binders and calibrated sand available in Beige and Slate Grey. The installation of SUPERSAND BOND is almost identical to using regular paver joint sand except for the application of water. Once SUPERSAND BOND polymeric sand sets, it becomes very firm and locks between the paver joints while still retaining flexibility and providing a long lasting, durable jointing material. SUPERSAND BOND is recommended for a variety of uses including pool decks, patios, footpaths, driveways, parking spaces, pavements etc.
IDEAL FOR:
- Residential use
- Traditional application
- Concrete pavers, wet cast products
- Sloping areas, pool surroundings, patios, walkways, driveways and more
FEATURES & BENEFITS:
- Advanced Haze Free Technology
- For Traditional application, rain safe 1 hour after water activation
- Can be used for joints up to a maximum of 1″ (2.5 cm)
- ASTM C-144 gradation of the polymeric sand allows use in even the tightest joints
- OSHA silica crystalline compliant (OSHA 29 CFR 1926.1153)
- Works above 32°F (0°C)
- Waterproof bags: Lay the bag flat on its back, so the front of the bag is facing you. Intact pallets can be stored outdoors
- 15-Year Limited Warranty
IMPORTANT INSTALLATION NOTES:
- Always refer to the latest SUPERSAND BOND Technical Data Sheet (TDS) at AllianceGator.com before installing SUPERSAND BOND.
- Pavers and slabs must be installed according to ICPI Tech Spec #2 (www.icpi.org) before SUPERSAND BOND installation. If pavers are installed over a concrete slab, (overlay application) Gator Maxx polymeric sand must be used. (Offered in USA only)
- Traditional Base application, using SUPERSAND BOND for pavers’ sides and top surfaces must be completely dry. Do not apply if the paver surface is damp or wet. The damp or wet surface will cause SUPERSAND BOND to prematurely activate and will lead to the polymers sticking on the paver surface.
- Do not apply if the paver joints are damp or wet. This will prevent the SUPERSAND BOND from properly sliding into the joints and obtaining very densely packed joints, which is critical to the products performance.
- Temperature must be above 32°F (0°C) with dry conditions (no rain for at least 1 hour) after installing SUPERSAND BOND.
- For all paver surfaces, and particularly around in-ground pools there must be a slope of 1/8″ (3 mm) per linear foot away from the edge of the pool, or structures to ensure optimal performance of the SUPERSAND BOND.
- For the pool coping units it is mandatory to use mortar in the joints. For the rest of the paver installation around the pool, you can use SUPERSAND BOND.
- Do not sweep SUPERSAND BOND over asphalt.
- SUPERSAND BOND level, must be at least 1/8″ (3 mm) below top of paver’s surface or 1/8″ (3 mm) below the chamfer or erosion may occur. The filled and cured polymeric sand joints should never be in direct contact with foot traffic or tires.
- For textured or pre-finished surfaces, we recommend to remove all the sand from the paver or slab surface prior to using the plate or roller compactor.
Reviews
There are no reviews yet.